Scanning - Yaesu VX-5R Operating Manual

Scanning

The VX-5R allows you to scan just the memory channels, the entire operating band, or a
portion of that band. It will halt on signals encountered, so you can talk to the station(s) on
that frequency, if you like.
Scanning operation is basically the same in each of the above modes. Before you begin,
take a moment to select the way in which you would like the scanner to resume scanning
after it halts on a signal.
Setting the Scan Resume Technique
Three options for the Scan-Resume mode are available:
: In this mode, the scanner will halt on a signal it encounters, and will hold
there for 5 seconds. If you do not take action to disable the scanner within that
time period, the scanner will resume even if the stations are still active.
: In this mode, the scanner will halt on a signal it encounters. Two seconds after
the carrier has dropped because the other station(s) ceased transmission, the
scanner will resume. In the case of constant-carrier signals like Weather Sta-
tion broadcasts, the scanner will likely remain on this frequency indefinitely.
: In this mode, the scanner will halt on a signal it encounters. It will not restart
automatically; you must manually re-initiate scanning if you wish to resume.
To set the Scan-Resume mode
Press the [ F/W ] key, then press the [ BAND ( SET ) AR ] key, to enter the Set mode.
Rotate the DIAL to select Menu #12 ("
Press the [ BAND ( SET ) AR ] key to enable changing of this Menu item.
Rotate the DIAL to select the desired scan-resume mode.
When you have made your selection, press the PTT key to save the new setting and
exit to normal operation.
The default condition for this Menu Item is "5 SEC."
46
").
VX-5R O
PERATING
M
ANUAL