Spanning-Tree Forward-Time <4-30; Spanning-Tree Hello Time <1-10 - Asus GIGAX 2024M Cli Manual

Syntax
Parameters
Command Mode Interface mode
No/clear
Show
Default
Description
Example
10.31 spanning-tree forward-time <4-30>
Syntax
Parameters
Command Mode Configure terminal mode
No/clear
Show
Default
Description
Example
10.32 spanning-tree hello time <1-10>
Syntax
Parameters
Command Mode Configure terminal mode
GigaX2024B/M L2 Managed Switch CLI Manual
spanning-tree edge-port
edge-port the interface is attached to a LAN segment that
is at the end of a bridged LAN or to an end node
No spanning-tree edge-port
show spanning-tree port detail IFNAME
None or depends on ODM customer
Use the spanning-tree cost configuration command on the switch
stack or standalone switch to set the spanning-tree interface
attached to a LAN segment that is at the end.
ASUS(config-if)# spanning-tree edge-port
spanning-tree forward-time <4-30>
forward-time
<4-30>
No spanning-tree forward-time
show spanning-tree port detail IFNAME
15 sec
Use the spanning-tree cost configuration command on the
switch stack or standalone switch to set the spanning-tree bridge
forward delay time (sec).
ASUS(config)# spanning-tree forward-time 15
spanning-tree hello time <1-10>
hello
time
<1-10>
the bridge forward delay time (sec)
Valid range is 4~30 secs
hello BPDUs
the interval (sec) between hello BPDUs
valid range is 1~10 secs
45