Shutdown; Default-Priority <0-7 - Asus GIGAX 2024M Cli Manual

GigaX2024B/M L2 Managed Switch CLI Manual
Command Mode Interface mode
No/clear
Show
Default
Description
Examples

15.15 shutdown

Syntax
Parameters
Command Mode Interface configuration
No/clear
Show
Default
Description
Examples
15.16 default-priority <0-7>
Syntax
Parameters
Command Mode Interface mode
200
no speed
show l2_interface IFNAME
None or depends on ODM customer
Use the speed configuration command on the switch stack or
standalone switch to set speed status of the port.
ASUS(config-if)#speed 100
shutdown
no shutdown
show running-config
The shutdown command for a port causes it to stop forwarding.
You can enable the port with the no shutdown command.
The no shutdown command has no effect if the port is a
static-access port assigned to a VLAN that has been deleted,
suspended, or shut down. The port must first be a member of an
active VLAN before it can be re-enabled.
Only one management VLAN interface can be active at a time.
The remaining VLANs are shut down.
In the show running-config command, the active management
VLAN interface is the one without the shutdown command
displayed.
ASUS(config-if)# shutdown
default-priority <0-7>
<0-7> Cos priority