Leica L2 Cold-Light Source - Leica M-Series User Manual

Changing fuses
Fuses 1.0A, 5 20 (stock no. 167 651)
In the event of overload
Step transformer
Follow the safety instructions given
on page 4.
• You can attach a 6V/10W lamp to the step transformer.
Use the rotary knob to adjust the
brightness. Above 6V the diode
shines.
Lamp off.
Power switch off.
Turn the fuse holder anticlock-
wise and extract it.
Fit a new fuse and replace the
fuse holder.
Lamp off.
Power switch off.
Wait a few seconds.
Power switch on.
Lamp on.
Set the voltage selector on the
rear side to 115V or 230V.
Attach the power cable to the
power supply.
Connect the lamp.
Adjust the brightness with the
three-step switch (4V/5V/6V).
Leica L2 Cold light source
The antistatic Leica L2 cold-light source is powerful, small, com-
pact, inexpensive and is suitable for simple observation tasks
with the Leica MS5 and MZ6 stereo microscopes. In addition to
one or two-arm light guides, corresponding accessories are also
available for the coaxial, vertical and transmitted-light illumina-
tion methods. The Leica L2 can be directly connected on the
stand.
The light guides can be mounted with arms in the threads on the
microscope carrier. For instructions on mounting on the clamp
for fibre-optic light guides, see page 28.
For a detailed information, refer to the separate user manual
Leica L2, M2-288-0de.
When in use, the Leica L2 fibre-optic light source must
always be locked into an adapter to ensure stability.
Adapter 300mm focusing drive
Adapter baseplate
When mounted on the baseplate, the light source can be used
as a stand-alone unit.
Secure the clamp to
the 300mm focusing drive by
tightening the screw.
Using the mounting rail, slide the
fibre-optic light source into the
adapter fork until it engages.
Using the mounting rail, slide the
fibre-optic light source into the
adapter fork until it engages.
27