Grandstream Networks HT701 User Manual page 21

Firmware Key
SSL Certificate
SSL Private Key
SSL Private Key
Password
ACS URL
ACS Username
ACS Password
Periodic Inform
Enable
Periodic Inform
Interval
Connection Request
Username
Connection Request
Password
System Ring Cadence
Call Progress Tones
Lock Keypad Update
Disable Voice Prompt
Disable Direct IP Call
NTP server
Allow DHCP option 42
to override NTP serve
Syslog Server
Grandstream Networks, Inc.
Used for firmware encryption. Should be 32 digit in hexadecimal representation. End
user should keep it blank.
The user specify SSL certificate used for SIP over TLS in X.509 format.
The user specify SSL private key used for SIP over TLS in X.509 format.
User specify password to protect the private key above.
User specify the Auto Configuration Server's URL (TR-069 protocol)
User specify the ACS Username
User specify the ACS password
Default is No. If set to YES, device will send inform packets to the ACS
Frequency that the inform packets will be sent out to the ACS
Set a user name for the ACS to connect to this device
Set a password for the ACS to connect to this device
Configuration option is set ring cadence on all FXS ports for all incoming calls. (Syntax:
c=on1/off1-on2/off2-on3/off3(only 3 cadences maximum)) Default is set to c=2000/4000;
(US standards)
Using these settings, users can configure tone frequencies and cadence according to
their preference. By default they are set to North American frequencies. Configure these
settings with known values to avoid uncomfortable high pitch sounds. ON is the period of
ringing ("On time" in 'ms') while OFF is the period of silence. In order to set a continuous
tone, OFF should be zero. Otherwise it will ring ON ms and a pause of OFF ms and then
repeat the pattern.
Example configuration for N.A. Dialtone:
f1=350@-13,f2=440@-13,c=0/0;
Syntax: f1=freq@vol, f2=freq@vol, c=on1/off1-on2/off2-on3/off3; [...]
(Note: freq: 0 - 4000Hz; vol: -30 - 0dBm)
Default is No. If set to "Yes", the configuration update via keypad is disabled.
Default is No. Disables the voice prompt configuration.
Default is No. Disables the Direct IP Call function.
URI or IP address of the NTP (Network Time Protocol) server. This parameter
synchronizes the date and time.
Default NO. Enables the DHCP server to handle the NTP Server via Option 42
The IP address or URL of System log server. This feature is especially useful for the ITSP
(Internet Telephone Service Provider)
HT-701 User Manual
Firmware Version 1.0.0.17
Page 21 of 31
Last Updated: 02/2012