3-Way Conferencing; Fax Support - Grandstream Networks HT701 User Manual

Attended Transfer
Assume that Caller A and B are in conversation. Caller A wants to Attend Transfer B to C:
1. Caller A presses FLASH on the analog phone for dial tone.
2. Caller A then dials Caller C's number followed by # (or wait for 4 seconds).
3. If Caller C answers the call, Caller A and Caller C are in conversation. Then A can hang up to
complete transfer.
4. If Caller C does not answer the call, Caller A can press "flash" to resume call with Caller B.
NOTE: When Attended Transfer fails and A hangs up, the HT701 will ring back user A to remind A that B
is still on the call. A can pick up the phone to resume conversation with B.

3-Way Conferencing

The HT701 supports Bellcore style 3-way Conference.
Instructions for 3-way conference:
Assume that call party A and B are in conversation. Caller A(HT701) wants to bring third Caller C into
conference:
1. A presses FLASH (on the analog phone, or Hook Flash for old model phones) to get a dial tone.
2. A dials C's number then # (or wait for 4 seconds).
3. If C answers the call, then A presses FLASH to bring B, C in the conference.
4. If C does not answer the call, A can press FLASH back to talk to B.
5. If A presses FLASH during conference, C will be dropped out.
6. If A hangs up, the conference will be terminated for all three parties when configuration "Transfer
on Conference Hangup" is set to "No". If the configuration is set to "Yes", A will transfer B to C so
that B and C can continue the conversation.

Fax Support

HT701 supports FAX in two modes: 1) T.38 (Fax over IP) and 2) fax pass through. T.38 is the preferred
method because it is more reliable and works well in most network conditions. If the service provider
supports T.38, please use this method by selecting Fax mode to be T.38 (default). If the service provider
does not support T.38, pass-through mode can be used.
Grandstream Networks, Inc. HT-701 User Manual
Firmware Version 1.0.0.17
Page 13 of 31
Last Updated: 02/2012