Grandstream Networks HT701 User Manual page 20

Via TFTP Server
Via HTTP / HTTPS
Server
Firmware Server Path
Config Server Path
XML Config File
Password
HTTP/HTTPS User
Name
HTTP/HTTPS
Password
Firmware File Prefix
Firmware File Postfix
Config File Prefix
Config File Postfix
Allow DHCP Option 66
to override server
Automatic Upgrade
Firmware Key
Authenticate Conf File If set to Yes, config file is authenticated before acceptance.
Grandstream Networks, Inc.
This is the IP address of the configured TFTP server. If selected and it is non-zero or not
blank, the HT701 retrieves the new configuration file or new code image from the
specified TFTP server at boot time. After 5 attempts, the system will timeout and will start
the boot process using the existing code image in the Flash memory. If a TFTP server is
configured and a new code image is retrieved, the new downloaded image is saved into
the Flash memory.
Note: Please do NOT interrupt the TFTP upgrade process (especially the power supply)
as this will damage the device. Depending on the local network, this process can take up
to 15 or 20 minutes.
The URL for the HTTP/HTTPS server used for firmware upgrade and configuration via
HTTP.
For example, http://provisioning.mycompany.com:6688/Grandstream/1.0.0.67":6688" is
the specific TCP port where the HTTP or HTTPS server is listening; it can be omitted if
using default port 80.
Note: If Auto Upgrade is set to No, HT701 will only do HTTP/HTTPS download once at
boot up.
IP address or domain name of firmware server.
IP address or domain name of configuration server.
The password used for encrypting the XML configuration file using OpenSSL.
This is required for the phone to decrypt the encrypted XML configuration file.
The user name needed to authenticate with the HTTP/HTTPS server.
The password needed to authenticate with the HTTP/HTTPS server.
Default is blank. If configured, HT701 will request firmware file with the prefix. This
setting is useful for ITSPs. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is blank. End user should keep it blank.
If set to "Yes", configuration and upgrade server information can be obtained using DHCP
option 66 from DHCP server located in customer's environment.
Choose "Yes" to enable automatic upgrade and provisioning. If select "Check every
minutes" input the amount of minutes you want it to check for update. If select "Yes, daily
at hour" make sure to input the hour of the day you want it to check for update, e.g. for 11
pm type 23. If select "Yes, weekly on day" make sure you input the day of the week (in
format 0-6, 0 is Sunday) you want it to check for update. When set to No, HT701 will only
do the following option you select; "Always check for New Firmware at Boot up" will check
for new firmware every time the device reboots. "Check New Firmware only when F/W
pre/suffix changes" will check for updates only when the pre/suffix has been changed.
Used for firmware encryption. Should be 32 digit in hexadecimal representation. End
user should keep it blank.
configuration from an unauthorized change.
HT-701 User Manual
Firmware Version 1.0.0.17
This protects the
Page 20 of 31
Last Updated: 02/2012