Heat Sink - HP ENVY 17 Maintenance And Service Manual

3. Lift the system board (1) , and then remove the system board (2) by sliding it up and to the right
at an angle.
Reverse this procedure to install the system board.

Heat sink

Description
For use only on computer models equipped with the Intel HM87 Express Chipset and an Nvidia
N14P-GT (GeForce 750M) graphics subsystem
For use only on computer models equipped with the Intel HM87 Express Chipset and an Nvidia
N14P-GV2 (GeForce 740M) graphics subsystem
For use only on computer models equipped with the Intel HM87 Express Chipset and a graphics
subsystem with UMA memory
NOTE: To properly ventilate the computer, allow at least 7.6 cm (3 in) of clearance on the left side
of the computer. The computer uses an electric fan for ventilation. The fan is controlled by a
temperature sensor and is designed to turn on automatically when high temperature conditions exist.
These conditions are affected by high external temperatures, system power consumption, power
management/battery conservation configurations, battery fast charging, and software requirements.
Exhaust air is displaced through the ventilation grill located on the left side of the computer.
Before removing the heat sink, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the display panel (see
6. Remove the service cover (see
78 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 39),
Display panel on page
Service cover on page
Spare part number
720233-001
720232-001
720231-001
50).
40).