Fan - HP ENVY 17 Maintenance And Service Manual

Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the display panel (see
5. Remove the service cover (see
6. Remove the hard drive (see
7. Remove the memory modules (see
8. Remove the WLAN module (see
9. Remove the optical drive (see
10. Remove the base enclosure (see
Remove the power connector cable:
1. Release the metal clip to disconnect the power connector cable (1) from the system board.
2. Disengage the cable from the clips (2).
3. Release the clips (3), and then remove the power connector cable (4).
Reverse this procedure to install the power connector cable and bracket.

Fan

Description
Fan (with foil)
74 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Display panel on page
Service cover on page
Hard drive on page 41).
Memory modules on page
WLAN module on page
Optical drive on page
Base enclosure on page
50).
40).
43).
44).
46).
55).
Spare part number
720235-001