Connector Board - HP ENVY 15 Maintenance And Service Manual

Connector board

Description
For use only on computer models equipped with an AMD processor
For use only on computer models equipped with an Intel processor and a graphics subsystem
with discrete memory
For use only on computer models equipped with an Intel processor and a graphics subsystem
with UMA memory
Before removing the connector board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service door (see
b. mSATA SSD (see
c. Hard drive (see
d. Base enclosure (see
Remove the connector board:
1. Disconnect the connector board cable (1) from the system board.
2. Release the connector board cable from the routing clips (2) built into the top cover and routing
channel (3) between the subwoofer and left front speaker.
3. Release the ZIF connector (4) to which the connector board ribbon cable is attached, and then
disconnect the connector board ribbon cable from the system board.
Battery on page 40), and then remove the following components:
Service door on page
mSATA SSD on page
Hard drive on page 45)
Base enclosure on page
41)
42)
52)
Component replacement procedures
Spare part number
720579-001
723372-001
720554-001
77