Power Connector Cable - HP ENVY 15 Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Power connector cable for use on computer models equipped with an Intel processor and a
graphics subsystem with discrete memory
Before removing the power connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service door (see
b. mSATA SSD (see
c. Hard drive (see
d. Base enclosure (see
Remove the power connector cable:
1. Disconnect the power cable (1) from the system board.
2. Release the power connector cable from the clips (2) built into the keyboard shield.
3. Release the power connector (3) from the clips and mold built into the top cover.
4. Remove the power connector cable (4).
Reverse this procedure to install the power connector cable.
Battery on page 40), and then remove the following components:
Service door on page
mSATA SSD on page
Hard drive on page 45)
Base enclosure on page
41)
42)
52)
Component replacement procedures
Spare part number
720537-001
720538-001
79