Touchpad Assembly - HP ENVY 15 Maintenance And Service Manual

TouchPad assembly

Description
TouchPad assembly (includes TouchPad bracket, TouchPad button board, TouchPad, and
cables)
Before removing the TouchPad, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service door (see
b. mSATA SSD (see
c. Hard drive (see
d. Base enclosure (see
e. System board (see
f. Front speakers (see
Remove the TouchPad:
1. Remove the two Phillips PM2.0×2.9 screws (1) that secure the TouchPad bracket to the top
cover.
Battery on page 40), and then remove the following components:
Service door on page
mSATA SSD on page
Hard drive on page 45)
Base enclosure on page
System board on page
Front speakers on page
41)
42)
52)
63)
85)
Component replacement procedures
Spare part number
722972-001
87