Base Enclosure - HP ENVY 15 Maintenance And Service Manual

Reverse this procedure to install the RTC battery. When installing the disc cell RTC battery, make
sure the "+" sign faces up.

Base enclosure

Description
Base enclosure (includes 4 rubber feet, battery lock latch, battery release latch, and RJ-45
cover)
Before removing the base enclosure, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
5. Remove the service door (see
6. Remove the mSATA SSD (see
7. Remove the hard drive (see
Remove the base enclosure:
1. Remove the front rubber feet (1).
The rubber feet are included in the Rubber Kit, spare part number 720559-001.
2. Remove the seven Phillips PM2.5×5.5 screws (2) in the that secure the base enclosure to
the computer.
52 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 40).
Service door on page
mSATA SSD on page
Hard drive on page
41).
42).
45).
Spare part number
720534-001