Shutdown Procedure; Safety Features; Damper Operation - Enerzone EUROZONE Owner's Manual

Table of Contents

SHUTDOWN PROCEDURE

Turning your ENERZONE stove off is a matter of pressing

temperatures have fallen to a preset level. The stove cannot restart before it has completely shut down.

Your stove is equipped with a manual reset high temperature switch (also called heat sensor or heat switch). The switch has a reset button on

its backside. Like a circuit breaker, once tripped, the reset button will have to be pushed before you can restart the stove. The high

temperature switch protects the stove against overheating due to of an evacuation problem, a control board problem, a blower problem, or any

other problem causing the unit to overheat. The manufacturer recommends that you contact your dealer if this occurs as it may hide a major

problem. A service call may be required.

NOTE: If an overheating situation occurs, the high temperature switch (called the L-250 manual reset) will automatically shut down the auger

motor (fuel feed system) and a warning code

If the combustion blower fails, an air pressure switch will automatically shut down the auger and a warning message

safety feature is to prevent the unit from igniting or burning fuel when the combustion/exhaust blower has failed, therefore preventing

combustion fumes from spilling into the room.

If the temperature in the auger rises beyond a certain acceptable level, two high temperature switches located under and above auger housing

will stop the fuel feed system and a warning

CODE

BEFORE RESETING

H1, H2, H3

Heat exchanger and/or exhaust system

OR H4

is/are clogged. Refer to the owner's manual

for maintenance procedures.

*** After 3 attempts, reset is no longer possible, call SBI technical support.

on the control panel. The blowers will continue to operate until internal firebox

will appear.

TO RESET

Press simultaneously for 2 seconds

Figure 39

Damper operation

icons.

will appear. This

and

Table of Contents