Vaccum Use; Cleaning - Enerzone EUROZONE Owner's Manual

Table of Contents

Advertisement

VACCUM USE

If a vacuum is used to clean your stove, we suggest using a vacuum designed for
ashes.
Some regular vacuums and shop vacs leak ash into the room. Your vacuum or
shop vac may have a special filter or bag available to eliminate this leakage.

CLEANING

a.
Heat Exchange Tubes – Your EUROZONE stove is designed with a
built-in heat exchanger tube cleaner.
remove accumulated ash on the tubes. Slide the cleaning rod back and
forth two or three times from front to back (refer to figure 43). When
finished, push the cleaning rod back in, behind the louvers.
b.
Baffle: Remove the baffle and scrape off ashes. Slide both sides toward
the center to remove the baffle(Figure 46) Use a vacuum is necessary. In
some cases, you will need to remove creosote on the baffle, which can
accumulate rapidly under certain conditions. A small wire brush can be
used.
It is important to remove this creosote because it is highly
combustible and could cause premature corrosion.
*When replacing the baffle, make sure that the open side of the baffle
is located on the left.
c.
Chamber walls: Periodically, you must vacuum the ashes that may have
accumulated on the main walls of the combustion chamber. START BY
REMOVING THE DECORATIVE MASONRY-LIKE PANELS, WHICH ARE
SIMPLY HELD BY CLIPS.
also a cleaning outlet located behind the left side panel of the combustion
chamber. Remove this panel using a screw driver. Loosen the adjustment
screws then remove the securing screws(Figure 47).
toward right(Figure 48), tilt it (Figure 49) then remove it from the
combustion chamber. Scrape off ashes. You will notice a small
rectangular cleaning outlet. Inspect behind this outlet (see Figure 50)
Insert the vacuum tip through the cleaning outlet and clean thoroughly.
REPEAT THIS OPERATION AT LEAST ONCE PER TON OF PELLETS
BURNED
UNTIL
ACCUMULATE WITH YOUR OPERATING PRACTICES.
d.
Convection blowers - Clean the blower's protective wire mesh regularly
as dust and hair build-ups on the mesh will reduce the efficiency of the
blowers and may cause the stove to overheat.
This should be used weekly to
The use of a vacuum is necessary. There is
YOU
ARE
FAMILIAR
WITH
Figure 47
Figure 49
Slide the wall
HOW
ASHES
21
Figure 46
Baffle removal
Figure 48
Figure 50

Advertisement

Table of Contents
loading

Table of Contents