Setting Up A Wireless Connection With Wps - D-Link DCS-5605 User Manual

Wireless n/wired poe ptz h.264 network camera

Hide thumbs Also See for DCS-5605:

Table of Contents

Section 3 - Configuration

Setting up a Wireless Connection with WPS

If your wireless access point or router supports push-button Wireless Protected Setup (WPS), you can quickly configure

your wireless network and camera without using the camera's web interface.

After plugging the power adapter to your camera and the front status LED lights up, hold down the WPS button on the

back of the camera for 3 seconds. After pressing the button, it should start flashing blue.

Now press the WPS button on your router or access point within 1 minute to activate WPS and allow your devices to

automatically configure a wireless connection. After WPS is successfully activated, the WPS LED on your camera will

stop flashing, and will light up solid blue, then reboot.

Note: On some routers/access points, you may need to enter the web interface to activate WPS. Consult your product's

user manual for further assistance.

WPS Button

Press this button to establish a WPS connection.

D-Link DCS-5605/5635 User Manual

Table of Contents

Dcs-5635