Table of Contents
Advertisement
Network Related & User Interface Commands
The AT Commands in this section aply to various network and user interface functions and
parameters. For futher information, refer to the Motorola C24 AT Command Set document available
from Motorola [1].
Table 10.14: Network Commands
Command
AT+CREG
AT+CSQ
AT+MSSI
AT+NETPAR
AT+MDISP
AT+MDORMANT
AT+MPREFMODE
AT+MBAND
Table 10.15: User Interface & Access Commands
Command
AT+CLAN
AT+CMER
AT+CIEV
AT+MMR
AT+MMRR
AT+CIND
A/
AT
AT+MPIN
AT+CPWD
AT+CLCK
AT+CCLK
AT+CPBS
AT+CPBR
AT+CPBF
AT+CPBW
Description
This command enables/disables the network status registration
unsolicited result code.
This command displays the signal strength received by the C24.
This command enables/disables the unsolicited report for signal
strength value.
This command displays information regarding the active, candidate,
and neighbor cell.
This command is used to display characters that the network sends to
the module.
This command enable/disable the dormant indication unsolicited
report.
This command configures System Select setting.
This command selects Preferred Band.
Description
This command handles the selection of language in the ME.
Mobile Equipment Event Reporting.
An unsolicited indication regarding various phone indications that is
sent to the DTE when the <ind> parameter of the +CMER command is
set to 1.
This command perform master reset.
This unsolicited message is sent to the DTE by the SMC modem if a
master reset occurs, and master reset events reporting is enabled.
This command is used to query the status of various ME indicators.
This command repeats the last command entered on the terminal.
This command checks the AT communication and only returns OK.
This command enables the accessory application to unlock the phone
when the appropriate unlock code has been provided.
This command sets a new password for the facility lock.
This command locks, unlocks or interrogates a SMC Modem or a
network facility <fac>.
This command reads/sets the SMC modem's current date and time
settings.
This command handles the selection of the memory to be used for
reading and writing entries that contain more than one phone book
memory.
This command recalls phone book entries from a specific entry
number, or from a range of entries.
This command searches the currently active phone book for a
particular entry, by name.
This command stores a new entry in the phone book, or deletes an
existing entry from the phone book.
001-0004-819 Rev01
Page 42 of 62
Advertisement
Table of Contents
