Adding A Second Hard Drive - Dell DIMENSION E510 DCSM Owner's Manual

Adding a Second Hard Drive

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product
Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before
removing the cover.
NOTICE:
To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a surface, such as
a foam pad, that will sufficiently cushion it.
1 Check the documentation for the drive to verify that it is configured for your computer.
2 Follow the procedures in "Before You Begin" on page 59.
3 Press in on the blue release tabs on each side of the hard drive bracket and slide it up and out of the
computer.
4 Snap the bracket to the hard drive.
5 Gently slide the new drive (second hard drive) into place until you feel a click or feel the drive securely
installed.
6 Connect a power cable to the drive.
7 Connect the data cable to the drive and to the system board (see "System Board Components" on
page 68).
release tabs (2)
second hard drive
in lower bay
hard drive bay
primary hard drive
in upper bay
Removing and Installing Parts
89