Addressing Memory With 4-Gb Configurations; Installing Memory - Dell DIMENSION E510 DCSM Owner's Manual

Channel A: matched pair of memory
modules in connectors DIMM_1
and DIMM_2 (white securing clips)
Channel B: matched pair of memory
modules in connectors DIMM_3
and DIMM_4 (black securing clips)
NOTE:
Memory purchased from Dell is covered under your computer warranty.
NOTICE:
If you remove your original memory modules from the computer during a memory upgrade, keep them
separate from any new modules that you may have, even if you purchased the new modules from Dell. If possible,
do not pair an original memory module with a new memory module. Otherwise, your computer may not start
properly. You should install your original memory modules in pairs either in DIMM connectors 1 and 2 or DIMM
connectors 3 and 4.

Addressing Memory With 4-GB Configurations

Your computer supports a maximum of 4 GB of memory when you use four 1-GB DIMMs. Current
operating systems, such as Microsoft
however, the amount of memory available to the operating system is less than 4 GB. Certain components
within the computer require address space in the 4-GB range. Any address space reserved for these
components cannot be used by computer memory.

Installing Memory

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product
Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your
body before you touch any of your computer's electronic components. You can do so by touching an unpainted
metal surface on the computer chassis.
1 Follow the procedures in "Before You Begin" on page 59.
2 Lay the computer on its side so that the system board is on the bottom of the inside of the computer.
3 Press out the securing clip at each end of the memory module connector.
70
Removing and Installing Parts
® ®
Windows XP , can only use a maximum of 4 GB of address space;