Installing A Media Card Reader - Dell DIMENSION E510 DCSM Owner's Manual

Installing a Media Card Reader

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your
body before you touch any of your computer's electronic components. You can do so by touching an unpainted
metal surface on the computer chassis.
1 Follow the procedures in "Before You Begin" on page 59.
2 Lay the computer on its side so that the system board is on the bottom of the inside of the computer.
3 Remove the computer cover (see "Removing the Computer Cover" on page 65).
4 Remove the drive panel (see "Removing the Drive Panel" on page 81).
5 Remove the Media Card Reader and bracket from its packaging and ensure that all of the screws are
included.
6 Gently slide the drive into place until you feel a click or feel the drive securely installed.
Ensure that the Media Card Reader is installed before the FlexBay cable is connected.
7 Connect the FlexBay USB cable to the back of the Media Card Reader and to the Media Card Reader
connector on the system board (see "System Board Components" on page 68).
96
Removing and Installing Parts
Media Card
Reader
screws (4)