Set Mode; I Set Mode Programming; I Set Mode Items - Icom IC-M603 Instruction Manual

I Set mode programming

Set mode is used to change the conditions of the trans-
ceiver's functions: Scan type*
tone, Internal speaker, LCD contrast, Automatic foghorn fre-
2
quency, Radio power* , Scrambler type*
and Favorite channel.
1
* Except for Holland version.
2
* Appears only when an optional COMMANDMICIII™ is connected.
3
* Appears only when an optional scrambler unit is installed.
Available functions may differ depending on dealer setting.
q While pushing and holding [!6 • C], push [POWER] to enter

Set mode.

• Turn power OFF in advance.
w After the display appears, release [!6 • C].
e Rotate [SELECTOR] to select the desired item, push [ENT].
r Rotate [SELECTOR] to select the desired condition of the
item, push [ENT] to set.
t Push [CLR], or rotate [SELECTOR] to select "
push [ENT] to exit Set mode and returns to normal condition.
• SET MODE CONSTRUCTION
Rotate
1 1
, Scan resume timer* , Beep
3
, Scrambler code*
" then

I Set mode items

D D Scan type
(Except for Holland version)
The transceiver has 2 scan types: normal scan and priority
scan. Normal scan searches all TAG channels in the selected
3
channel group. Priority scan searches all TAG channels in se-
quence while monitoring Channel 16.
D D Scan resume timer
The scan resume timer can be selected as a pause (OFF) or
timer scan (ON). When OFF is selected, the scan pauses
until the signal disappears. When ON is selected, the scan
pauses 5 sec. and resumes even if a signal has been re-
ceived on any other channel than Channel 16.
SET MODE
(Default: Normal)
(Except for Holland version)
(Default: OFF)
8
7
8
43