I Call Channel Programming; Basic Operation; I Automatic Backlighting - Icom IC-M3EURO Instruction Manual

3

BASIC OPERATION

I Call channel programming

The call channel switch is used to select a specified channel,
however, you can program your most often-used channels in
each channel group for quick recall.
q Push [16 •
] for 1 sec. to select
C
the call channel of the selected
channel group.
• "CALL" and call channel number
appear.
w Push [16 •
] again for 3 sec.
C
(until long beep changes to 2
short beeps) to enter call chan-
nel programming condition.
• Call channel number and channel
group to be programmed flash.
r Push [
]/[ ] to select the de-
sired channel.
t Push [16 •
] to program the dis-
C
played channel as the call chan-
nel.
• The call channel number and chan-
nel group stop flashing.
8

I Automatic backlighting

This function is convenient for nighttime operation. The auto-
CALL CALL
TAG matic backlighting can be activated in SET mode. (p. 12)
INT
Push any key except for [PTT] to turn the backlighting ON.
CALL CALL
TAG
INT
CALL
TAG
INT
CALL
TAG
INT
NOTE: For the UK and Italy versions, push [CH •
1 sec. in advance to select the desired channel group
(INT, U.S.A.) to be programmed.
• The backlighting is automatically turned OFF after 5 sec. of in-
activity.
] for
I/U