Icom IC-F3062T Instruction Manual page 24

4
BIIS OPERATION
D D Direct code entry
q While in the standby condition, push [TX Code Enter] to
enter the TX code edit mode.
• Code digit for editing blinks.
0500
CALL CALL BIFN BIFN
w Push [TX Code Enter] to select the desired digit to be edited.
• Digit for editing differs according to the setting.
e Set the desired digit using [CH Up]/[CH Down] or 10-key-
pad*.
*IC-F3062T/IC-F4062T (10-key type) only
r Push [TX Code Enter] to set the digit, then the digit to the
right will blink automatically.
• When the 10-keypad is used for setting, the digit to the right will
blink automatically without pushing
t Repeat e and r to input all allowable digits.
y Push [Call] or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
W W A A I I T T
and
" "
error beep sounds and
answer back is received after the calls.
20
TXC TXCE TXCE
[TX Code Enter]
is displayed during each call. However, an
"F F A A I I L L E E D D "
is displayed when no
u Push [PTT] to transmit; release to receive.
i Push [Moni(Audi)] to send the 'Clear down' signal.
For your information
When the "UpDate" setting for the call code is enabled, the
set code is overwritten into the call code memory.
.