Kodak 3000 series User Manual page 74

Troubleshooting
14. Using the wrong media size.
Possible Cause
Are you using approved
media?
Is the hold lever down?
When the media is loaded, is
the curled media facing
upward?
Are you using the printer in a
wrong environment?
Is the media sensor dirty?
Are you reusing the media?
15. During printing, the media gets stuck.
Possible Cause
Are you using approved
media?
Is the hold lever down?
In case of using roll media, is
the edge of the media parallel
with the baseline, during the
media detection sequence?
Is the Scroller installed
correctly?
16. The printer does not work with a Centronics interface cable.
Possible Cause
Is the Centronics interface
cable connected?
When the printing data is sent
from your station, does the
data LED light?
Are the printer Centronics
setup mode and timing
compatible with the computer
settings?
Is the type of command
compatible with your
computer and driver?
Solution
Use only approved media.
Make sure to hold the lever
down.
Either remove the curl or
replace the media.
Use the printer in the
approved environment.
Clean the media sensor.
Use new media.
Solution
Use only approved media.
Make sure to hold the lever
down.
The roll media and the
baseline should be set
parallel.
Install the Scroller correctly.
Solution
Make sure to connect the
Centronics interface cable.
If the data indicator is not lit,
contact your computer dealer.
Make sure the printer and the
computer's timing are
compatible.
Check 'user' and 'command'
setup.
KODAK PROFESSIONAL Large
Format 3000 Series Inkjet Printers
Reference
Setting Up the Printer
Setting Up the Printer
Setting Up the Printer
Installing the Printer
Maintaining the
Printer
Reference
Setting Up the Printer
Setting Up the Printer
Setting Up the Printer
Installing the Printer
Reference
Setting Up the Printer
69