(M Key) Is For Controlling Cuddeback - Cuddeback NoFlash Owner's Manual

STEP 5 - KEY IS FOR CONTROLLING
CUDDEBACK
Press to view information and to set the
operating mode.
1) View Date and Time
until the date/time is displayed on the LCD display.
2) View Images Saved - Press
will display [DO NOT REMOVE CARD] as the
Compact Flash Card is read. In a few seconds
the LCD will display the number of images saved
on the Compact Flash Card
3) Set the Camera Mode - Press
of Cuddeback's 3 camera modes (Standby,
Test, and Live) will be displayed
Press or
camera mode.
a) Standby - Cuddeback will not trigger the camera.
b) Test Mode - The red LED will illuminate when
activity is sensed but the camera will not trigger.
c) Live Mode - Cuddeback will trigger the camera
when activity is sensed. The red LED will NOT
illuminate. About 45 seconds after [Live Mode]
is displayed the LCD will clear.
(figure 15) - Press
again. The LCD
(figure 16).
again. One
(figure
as needed to change the
TIP - After Live Mode is displayed
there is a 45 second delay before
the motion sensor starts. This
gives you time to install the cover
and move out of the area without
17).
triggering the camera.
After setting up Cuddeback, install
the cover and leave the area. You
can leave the Camera Mode in
Standby or Test and Cuddeback
will automatically arm itself within
12 minutes.
12
4/05/06
11:13
AM
Figure 15
Images
19
Figure 16
TestMode
Figure 17