Table of Contents
Advertisement
alternative routes, the one with the lowest hop count is
considered the fastest path.
4)
Select Send Mode and Receive Mode.
The Send Mode setting indicates the RIP version this
interface will use when it sends its route information to
other devices.
The Receive Mode setting indicates the RIP version(s) in
which information must be passed to the MT800 in order
for it to be accepted into its routing table.
5)
Click the Add button. The new RIP entry will display in the
table.
6)
Click the Enable radio button to enable the RIP feature.
Note:
RIP version 1 is the original RIP protocol. Select RIP1 if you have devices that
communicate with this interface that understand RIP version 1 only.
RIP version 2 is the preferred selection because it supports "classless" IP
addresses (which are used to create subnets) and other features. Select RIP2 if
all other routing devices on your LAN support this version of the protocol.
III.
Save
Click the Submit button to save the settings in the RAM.
To save these configuration changes permanently, enter
the Save & Reboot page, select Save and click Submit
button to save new settings.
46
Advertisement
Table of Contents
