Table of Contents
Advertisement
VCI: If you need any modification, please enter the VCI
value provided by ISP. See the attached table for all the
VCI default value of PVC.
Operation Mode: This also should be left at the default
setting Enabled. This enables the PVC used for the initial
connection.
Encapsulation: You can select the mode LLC or VC MUX.
PPPoA / PPPoE: Please select "PPPoE".
IP Unnumber: You can select enable or disable. When
Enabled is selected, the Ethernet port address will be used
as your IP address.
Traffic Index: Select the index number for ATM traffic from
the pull-down menu.
Default Route: This setting specified the IP address below
is using for default route of LAN. The data will be sent
through WAN interface whenever a client LAN computer
accesses the Internet.
Username and Password: Enter the username and
password provided by ISP.
Use DNS: It is recommended to keep this option as Enable,
indicating that when PPP dial applies for IP and gateway, it
also tries for DNS server IP at the same time. On the other
hand, keep this option as disable, indicating that obtaining
DNS server not from PPP dial, and needed to manually
type in the addresses of primary DNS server and
secondary DNS server on the DNS configuration page.
Configured MTU: Enter the maximum bytes of the packet
being transmitted during connection.
28
Advertisement
Table of Contents
