Table of Contents
Advertisement
used for all destinations for which no other routes are
defined (this is the route that creates the default gateway).
Netmask: Indicating which parts of the destination address
refer to the network and which parts refer to a computer on
the network. The default gateway uses a netmask of
0.0.0.0.
Next Hop: Specifying the next IP address to send data to
when its final destination is that shown in the destination
column.
IF Name: Displaying the name of the interface through
which to data is forwarded to the specified next hop.
Route Type: Displaying whether the route is direct or
indirect. In a direct route, the source and destination
computers are on the same network, and the MT800
attempts to directly deliver the data to the computer. In an
indirect route, the source and destination computers are on
different networks, and the MT800 forwards data to a
device on another network for further handling.
Route Origin: Displaying the origin of the route. Dynamic
indicates the route automatically produced by the device
interface address. Routes you create are labeled Local.
Other routes learned from route protocol are labeled the
name of the corresponding route protocol (for example,
origin of the route learned from RIP is labeled RIP).
III.
Save
Click the Submit button to save the settings in the RAM.
To save these configuration changes permanently, enter
the Save & Reboot page, select Save and click Submit
button to save new settings.
38
Advertisement
Table of Contents
