Table of Contents
Advertisement
VCI: If you need any modification, please enter the VCI
value provided by ISP. See the attached table for all the
VCI default value of PVC.
Operation Mode: This also should be left at the default
setting Enabled. This enables the PVC used for the initial
connection.
Encapsulation: You can select the mode LLC or VC MUX.
Connection Type: The bridged connection modes include
Pure Bridge, Static IP and DHCP.
Traffic Index: Select the index number for ATM traffic from
the pull-down menu.
Configured MTU (Maximum Transmission Unit): Enter
the maximum bytes of the packet being transmitted during
connection.
II.
Static IP
The setting page displayed as below will appear while you
select Static IP setting mode. Please fill the corresponding field with
the IP address and network mask provided by ISP. The default
setting of route is "Disable", and the Gateway IP address is "0.0.0.0."
The recommended setting is to enable default route and enter the
Gateway IP address provided by ISP.
19
Advertisement
Table of Contents
