Table of Contents
Advertisement
ADMINISTRATION – BASIC PAGE PIC
The JS100 unit is also capable of synchronizing the date and time settings on the network. JS100
units that are on networks connected to the Internet should usually be set up to do this. This kind of
network time synchronization is done through an international standard called Network Time
Protocol (NTP).
There is space opposite NTP Servers to type the IP addresses of three machines for the JS100 unit
to use for determining the current date and time. The default IP addresses are 192.5.41.40,
192.5.41.41, and 133.100.9.2. The first two of these IP addresses are servers run by the United
States Naval Observatory as a public service to provide the precise time over the Internet. The third
is a similar time server in Japan. These are generally good choices for time servers.
Use the spaces opposite the Time Zone Region, Time Zone Country, and Time Zone City to
make local time zone settings.
To perform a software reboot of the JS100 unit system, click Reboot.
To restore the JS100 unit system to the factory settings, click Restore Defaults.
Firmware Administration
On the Firmware Administration page, you can view the current JS100 unit firmware version and
update the firmware to a newer version, if available. Always note the version information when
contacting technical support.
To update the firmware
1
Download the new version of the firmware to a PC that is connected to the JS100 unit.
2
Click Browse.
3
Click the name of the downloaded file, and then click Open.
4
Click Update.
Caution! The update process takes several minutes. Do not turn off the JS100 unit while the
Page
14
©2005 Quasarbiz
Document: VS100UM101
Advertisement
Table of Contents
