14
21. Remove the six (6) Phillips screws (A‐1) from the backside of the
console (A) and set aside.
22. Feed wire connectors C‐20 & C‐21 through the backside of the
console hinge cover (A‐2). While supporting the console (A), join
connectors A‐4 & C‐20. Join connectors A‐3 with C‐21. Ensure
that all connections are firm.
23. Tilt the console mounting plate (B‐1) toward the rear of the unit.
Install two (2) Phillips screws (A‐1) through the underside of the
console mounting plate and into the backside of the console. The
screws must be installed in the two uppermost holes as shown.
24. Align the console hinge cover (A‐2) with the mounting holes on
the backside of the console by sliding the cover's slots over the
base of the hinge mount. It may be necessary to tuck any extra
cables into the console mast.
25. Re‐install the four (4) remaining Phillips screws (A‐1) through the
backside of the console hinge cover (A‐2) and tighten firmly.
26. Bring the upper console mast covers (B‐11L & B‐11R) together
over the top of the console mast as shown in the figure to the
left. Install the three (3) Phillips screws (I‐1).
27. Install the two (2) Phillips screws (B‐2) through the covers (B‐11L
& B‐11R) and into the console mast.
28. Roll the cycle to its final position by lifting the rear stabilizer until
the wheels on the front stabilizer touch the ground. Carefully
return the unit to the floor. This may require more than one
person.
29. Plug one end of the power supply (R) into a 120V power source.
Plug the opposite end into the input jack (C‐18) located near the
floor at the front of the unit.
30. Ensure the unit is stable and does not rock from side to side.
Level the four (4) stabilizer feet (K‐5) as needed. To extend a
stabilizer foot toward the ground, rotate it clockwise when
viewing from above.