Diamondback 510Sr Owner's Manual page 12

7. Identify the left and right pedals. The ends of the pedal axles are marked with an "L" for left and "R" for right. Install the right pedal
(C‐13R) into the right crank by hand, rotating the axle in a clockwise direction.
8. Thread the left pedal (C‐13L) into the left crank by hand in a counter‐clockwise direction.
9. Use the enclosed pedal wrench to firmly affix the pedals to the cranks. Retighten pedals after approximately ten (10) hours of use.
10. Tighten the left and right crank Allen bolts (C‐25) with the Allen wrench provided. Retighten after roughly ten (10) hours of use.
11. Remove the four (4) Allen screw and flat washer assemblies (N‐3 & N‐4) from the back of the seat back mast (M). Reinstall these
assemblies through the back side of the handlebar assembly (O) and into the seat back mast (M). Tighten firmly.
12. Plug rear heart rate connector (G‐1) into the pulse wire input jack (O‐4).
12