3-2 Mounting the Tool Holders
Mounting Tool Holders in the Magazine
The magazine is a "box" for storing the tool holders you use for cutting. Before you start cutting, load it with the needed
tool holders.
Procedure
52
Chapter 3 Basic Operation
Close the spindle cover.
Perform manual feed to move the
table all the way to the front.
In VPanel, click the [Attach/Detach] icon.
WARNING: This procedure
makes the machine operate. Before
you perform this procedure, check
to make sure that operation of the
machine will not create any hazard
or danger.
Click [Open Magazine Cover].