2-2 Step 1: Attach the Control Box
Attach the Control Box
Procedure
Continue by proceeding with "2-3 Step 2: Attach the Magazine Unit."
32
Chapter 2 Basic Operation
Prepare the modeling machine.
Perform manual feed to move the
table to the front.
Use manual feed to move the
spindle head to a position about half-
way along the X axis and at the lowest
location on the Z axis.
Shut down the modeling machine
and disconnect the power cable.
WARNING: Be sure to discon-
nect the power cable. Failure to do
so may result in danger of injury.
Remove the two screws.
Use the screws to attach the control
box.