Table of Contents
Advertisement
3-1 Starting and Quitting
How to Start the Machine
When this unit is installed, the procedure for starting the modeling machine changes slightly. Initialization cannot be performed
while a tool holder remains gripped by the spindle. This means that if a tool holder remains gripped, it must be released when
you begin startup. When a tool holder does not remain gripped, the startup procedure does not change.
Procedure
ON
50
Chapter 3 Basic Operation
Tool held --
Doing forced release.
Support tool and
Press CLEAR
Close the spindle cover.
Switch on the power switch.
If a tool remains gripped, this screen
appears on the handy panel.
When the tool interferes with a work:
When the tool interferes with a work, you can
raise the spindle by holding down the [Z] key
on the handy panel and rotating the MPG
(handle) in a clockwise direction.
Advertisement
Table of Contents
