Table of Contents
Advertisement
4-3 Entering Adjustment Values Yourself
Entering Adjustment Values
When you've measured tool length yourself, follow the procedure below to register the adjustment values.
Procedure
About the Offset Numbers
The numbers displayed in the [Length Offset] dialog box are the offset numbers. In the NC-code mode, the offset numbers
may not necessarily be identical to the stocker numbers. It's important to remember that, for example, offset No. 2 may be
assigned to stocker No. 1. In the RML-1 mode, it's not necessary to be aware of any differences between stocker numbers
and the offset numbers.
☞ P. 64, "Correspondences Between Stocker Numbers and Offset Numbers"
62
Chapter 4 Tool-length Offset
In VPanel, click the [Length Offset]
icon.
Enter the adjustment value.
Click [OK].
Advertisement
Table of Contents
