Electrical Connection (U.k. Only) - DeLonghi PACCS 600ECO Instruction Booklet

GB-5750004200 11-02-2004
ACCESSORIES
DRAWING
TECHNICAL SERVICE
Keep the list of Technical Service Centres in a
safe place and check to find the closest Centre
(though we hope you will never have to seek their
help).

ELECTRICAL CONNECTION (U.K. ONLY)

A) If your appliance comes fitted with a plug, it will incorporate a 13
Amp fuse. If it does not fit your socket, the plug should be cut off
from the mains lead, and an appropriate plug fitted, as below.
WARNING: Very carefully dispose of the cut off plug after remov-
ing the fuse: do not insert in a 13 Amp socket elsewhere in the
house as this could cause a shock hazard.
With alternative plugs not incorporating a fuse, the circuit must be
protected by a 15 Amp fuse.
WARNING - THIS APPLIANCE MUST BE EARTHED
The wires in the mains lead are coloured in accordance with the
following code:
Green and yellow:
Blue:
Brown:
18
9:12 Pagina 18
DESCRIPTION
Wall-attachment bracket
Support block for external unit
Anchor screws + screws ø 6 mm
Screws M6 mm
Screws M4x25 mm
Belt with hooks
Screw eye for a belt
Sheathing frame
Castor stop
Drain connection for condensation
with seal and two 4.2 penetrating
screws
Castors for the external unit and
washers
IMPORTANT
Earth
Neutral
Live
NO. PIECES PROVIDED
This appliance has been fitted with an HE (High
Efficiency) system for low energy consumption,
so after turning the appliance on you may have to
wait a few minutes for cool air to begin circulating.
If the plug is a moulded-on type, the fuse cover must be re-fitted
when changing the fuse using a 13 Amp Asta approved fuse to BS
1362. In the event of losing the fuse cover, the plug must NOT be
used until a replacement fuse cover can be obtained from your
nearest electrical dealer. The colour of the correct replacement
fuse cover is that as marked on the base of the plug.
B) If your appliance is not fitted with a plug, please follow the instruc-
tions provided below:
As the colours of the wires in the mains lead may not correspond with
the coloured markings identifying the terminals in your plug, proceed
as follows:
The green and yellow wire must be connected to the terminal in the
plug marked with the letter E or the earth symbol
green or green and yellow.
The blue wire must be connected to the terminal marked with the letter
N or coloured black.
The brown wire must be connected to the terminal marked with the
letter L or coloured red.
2
2
4
2
4
2
2
1
2
1
4
or coloured