Log Set Placement (Optional); Thermostat Installation - Quadra-Fire CASTILE-CE-MBK Owner's Manual

Castile & santa fe pellet stove
Table of Contents

Advertisement

Castile & Santa Fe CE Pellet Stove
B. Optional Log Set Placement Instructions
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
NOTE:
Due to the abrasive nature of a pellet appliance fire, the
logs are not covered under warranty. Any placement varia-
tion other than shown here can cause excessive heat and
shall void the appliance warranty.
Two Piece Log Set Installation
1. Open door to expose the firebox.
2. Install the left log first and then the right log. Figure 33.1
3. Lean the logs against the cast iron brick in the back of
the firebox.
4. Push the logs to the far left and far right against the
sides of the firebox. Figure 33.2.
5. To clean the logs, use a vaccum and a soft brush attach-
ment or a paint brush.
Figure 33.1
Figure 33.2
October 24, 2011
C. Thermostat Installation
1
A 12 volt AC thermostat is required to operate this pellet
.
appliance. You may use the included wall mount ther-
mostat or purchase an optional programmable thermo-
stat or remote control. It is equipped with an adjustable
heat anticipator. The current rating is .05 amps. The
anticipator needs to be adjusted to the lowest setting
available.
2. When mounting a thermostat on a wall, be sure to follow
your thermostat installation instructions carefully.
NOTE: Thermostat must be mounted level for accu-
rate readings. The thermostat should be mounted
on an inside wall and not in direct line with the
appliance convection air.
NOTE: If the thermostat is located too close to the
appliance, you may need to set the temperature
setting slightly higher to maintain the desired tem-
perature in your home.
3. There is a 4 screw terminal block located on the back
lower left corner of the stove directly above the power
cord inlet. The center 2 screws are for the thermostat
wires.
Shock hazard.
• Do NOT remove grounding prong from plug.
• Plug directly into properly grounded 3 prong
receptacle.
• Route cord away from appliance.
• Do NOT route cord under or in front of appli-
ance.
TERMINAL BLOCK
CENTER 2 SCREWS FOR
THERMOSTAT WIRES
POWER OUTLET
Figure 33.3
7068-112B
CAUTION
R
Page 31

Advertisement

Table of Contents
loading

This manual is also suitable for:

Santafe-ce-mbk

Table of Contents