Section 9: Appliance Set-Up; Outside Air Installation - Quadra-Fire CASTILE-CE-MBK Owner's Manual

R
9
Appliance Set-Up
A. Outside Air Kit Instructions
(Shown on SANTA FE)
Parts Included in Kit: 1 piece of 51mm x 914.4mm flex
hose, 2 hose clamps, 1 air intake channel1 collar assembly,
1 termination cap assembly, 1 trim ring, 12 screws. (Discard
air channel it is not need for this appliance).
Tools Needed: Phillips head screwdriver; wire cutters; hole
saw or jig saw.
1. Measure distance from floor to air vent opening in stove
and mark location on wall.
Use saw to cut opening in wall. Cut a 64 to 76mm open-
ing on inside wall and a 76 to 89mm opening on outside
of house.
2. Remove cover plate and then install the collar assembly.
3. Use hose clamp to secure flex pipe to collar assembly.
4. Slide trim ring over flex pipe and run pipe through wall.
5. Attach hose to outside termination cap with second hose
clamp.
6. Secure termination cap to outside surface.
7. Secure trim ring to interior wall.
Collar
Assembly
Flex Hose
Figure 32.1
Page 30
Hose Clamp
Trim Ring
Termination Cap
7068-112B
Castile & Santa Fe CE Pellet Stove
Termination
Cap Assembly
Hose Clamp
Trim Ring
Flex Hose
Hose Clamp
Collar Assembly
Figure 32.2
CAUTION
Never draw outside combustion air from:
• Wall, floor or ceiling cavity
• Enclosed space such as an attic or garage
Air Intake Channel
(Discard)
October 24, 2011