Appliance Set-Up; Rear Shroud Installation - Quadra-Fire CB1200 Installation Manual

CB1200 Pellet Insert
6

Appliance Set-Up

A. Rear Shroud Installation
Tools Required:
Electric drill, #26 drill bit, Phillips screw driver, 3/8 inch
wrench, and 7/16 inch socket wrench.
Needed to complete installation of the Rear Shroud
Assembly; 811-0680, will need to purchase one of the
following kits:
3 Inch Top Vent
Adapter (811-0660)
Do not drill any holes into the appliance until the
shroud assembly is attached to the appliance via
screws completely; this will ensure the holes line up
between the appliance and the shroud assembly.
1. Remove the top vent adapter from the vertical exhaust
transition pipe (Figures 20.1 and 20.2).
Figure 20.1
Figure 20.2
Note for the follow step verify the use of the correct
hole placement for the filler piece attachment.
Use the two holes Use the two holes
20
4 Inch Top Vent
or
Adapter (811-0670)
Remove top vent
adapter from the
this adapter
2. Using a Phillips head screwdriver and two screws to
attach Filler Bracket (Figure 20.3).
Figure 20.3
Verify gasket is installed between adapters before moving
onto the next step. Failure to do so may cause leaking of
soot and smoke into the home.
3. Using a 3/8-nch wrench and 7/16-inch socket wrench
fasten Rear Shroud Top Vent to the the exhaust
transition with two bolts and two nuts. Secure with two
clamps from the appliance (Figures 20.4 and 20.5).
Figure 20.4
Figure 20.5
7014-285C
Attach bolts and nuts in
these locations.
August 1, 2018