Introduction
Topics in this chapter:
About This Guide
on page 1
Related Documentation
Notation Conventions
Contacting Customer Support
About This Guide
This guide describes how to set up the HP
Effects, Finishing, or Colour Grading application. This includes Autodesk
Effects and Finishing applications: Autodesk
®
Smoke
, and Autodesk
NOTE In most cases, both hardware setup and application installation is done on delivery by an authorized
technician. If this is the case, please keep this guide as a reference, in case you decide to move the workstation,
change a peripheral, replace an adapter card, etc.
Related Documentation
This release has additional documentation to help you install, configure, and use the hardware and software.
At various places in this guide, references are made to other documents. Depending on your hardware and
software configuration and network topology, you may want to have additional documentation on hand
before you begin setting up the hardware:
Autodesk Visual Effects and Finishing Installation and Configuration Guide
Autodesk Lustre Installation and Configuration Guide for Linux Workstations
on page 1
on page 2
on page 2
®
®
Backdraft
Conform.
®
Z800 workstation hardware and wiring for an Autodesk
®
®
Inferno
, and Autodesk
1
®
®
Lustre
, and the following Visual
®
®
®
Flame
, Autodesk
Flint
®
Visual
®
®
, Autodesk
1