Connecting The Slave Renderer To A Lustre Workstation - HP Z800 Hardware Setup Manual

To USB extender
Network Switch
Ports 3 and 4 to
additional panels
Autodesk Control Surface
NOTE The illustration shows the central panel only (the Colour Grading panel). This panel is easily identified,
since it has both an Ethernet network port and a USB connector. It is also the panel with the built-in tablet.
To connect the Autodesk Control Surface:
1 Connect each panel to a power supply using the AC power adapter cables.
2 Use network cables to connect each panel to the available ports in the network switch.
3 Additionally, connect the Colour Grading panel to the remote unit of the USB extender kit.
4 Use a network cable to connect an available port on the Netgear network switch to the workstation s
on-board GigE port 1, as illustrated.

Connecting the Slave Renderer to a Lustre Workstation

The Lustre Slave Renderer is a single render node that provides automatic background rendering on a
shot-by-shot basis. It is available for the Lustre Master Station, the Station, and the HD Station.
16 | Chapter 3 Connecting Peripherals
HP Z800 Workstation
NETGEAR
PWR
1 2 3 4 5 6
To port 1 on USB Extender
Tablet
5V DC 4A Ethernet
+ -
7 8
Autodesk