Setting Up Vtr Emulation - HP Z800 Hardware Setup Manual

from house sync generation
(Trilevel/NTSC/PAL not included) SD/HD SDI
SD/HD SDI In / Out
Ch. 1/2 In Ch. 3/4 In Ch. 5/6 In Ch. 7/8 In Ch. 1/2 Out Ch. 3/4 Out Ch. 5/6 Out
AJA BOB (Front)
AJA BOB (Back)
AJA K3-Box
www.aja.c om 102053
Connect to Ho st
J1 In 1/A In 2/B Out 1/A Out 2/B
HD-SDI Out 2/B to 4:4:4 VTR (dual link 0:2:2)
HD-SDI Out 1/A to 4:2:2 VTR (or 4:4:4 dual link)
HD-SDI In 2/B to 4:4:4 VTR (dual link 0:2:2)
HD-SDI In 1/A to 4:2:2 VTR (or 4:4:4 dual link)

Setting Up VTR Emulation

You can configure your Autodesk Visual Effects, Finishing, and Colour Grading application to emulate a
VTR for both input and output in real time. You control the emulator from the application or device that
sees the Autodesk Visual Effects, Finishing, and Colour Grading application as a VTR.
The following procedure describes how to configure the hardware for VTR emulation. Consult the "VTR
Emulation" chapter in your application User Guide for more information.
HP Z800 Video I/O
to RS-422 VTR
machine control
In / Out
AES/EBU
Audio Video MonitorOut
In In In In
Y/G/CVBS Pb/B/Y Pr/R/C
Out Out Out Out
Ch. 7/8 Out Ch. 1/2 Ch. 3/4 Ch. 5/6 Ch. 7/8 SDI 1/A SDI 2/B Ref Loop
Sync loop out to
NVIDIA Input
Control cable and power
Graphics Monitor
VGA VGA DVI
SD/HD SDI IN 2
SD/HD SDI IN 1
SD/HD/SDI Monitor
(not included)
RS-422
Ch.1(L) Ch.2(R)
For Real-Time Deliverables
OUT 1 INPUT
OUT 2
AJA HD5DA
"Key" to SD/HD SDI Link B,
To SD/HD SDI
on VTR (for dual link)
Link A onVTR
Setting Up VTR Emulation | 21
"Fill" to Input