Table of Contents
Advertisement
"Model 64100A - General Information
SECTION I
GENERAL INFORMATION
1-1.
MANUAL INTRODUCTION.
1-2. This manual contains technical information to troubleshoot,
install,
and
maintain the
64100A
Logic Development Station.
Each
of the
five
chapters
(Mainframe, CPU, Display Controller,
I/O, and Power Supply)
is seperated by a
Tab.
This allows the user to easily find any chapter.
1-3. Each of the
five chapters is organized
into eight sections:
Section
I
introduces the reader to the manual and gives a brief
physical description
of
the product.
Section II presents the installation and removal procedures for
the system components.
Section III covers operation and handling.
Section IV
describes how
to troubleshoot and
repair the system.
Section V references
those components that have adjustments.
Section VI lists the replaceable parts
and Section VII contains backdating information needed to
make
this
manual
applicable to older machines.
Section VIII presents the theory-of-operation to
the
block
diagram
level
and
is
intended
to
support
the troubleshooting
procedures.
1-4.
CHAPTER INTRODUCTION.
1-5. This chapter
contains technical information
concerning the installation,
maintenance,
troubleshooting and theory-of-operation of the 64100A Mainframe.
The information contained in the Mainframe Chapter describes the overall system
and how
the
various components
relate to each
other
with the
emphasis on
troubleshooting and repairing.
More detailed information on the components can
be found under the respective Chapter
or the component in question (i.e., CPU,
DISPLAY CONTROLLER and DRIVER, I/O, POWER SUPPLY, and OPTIONS).
1-6.
PHYSICAL DESCRIPTION.
1-7. The 64100A Mainframe is a single enclosure similar to a CRT terminal
(see
figure 1-1).
It weighs 34.02 Kg (75 pounds)
and thus some care should be used
in moving it.
The
Mainframe dimensions are given
in figure
1-2.
The five
major areas of the developement station mainframe are:
a. CRT Display
b. Keyboard
c. Rear Panel
d. Card Cage
e. Power Supply
1-8.
The four areas of display
generation consist
of
the display controller
board, display driver, the CRT and CRT bezel assembly.
MF 1-1
Advertisement
Table of Contents
Troubleshooting
