Table of Contents
Advertisement
Your unit should start within 10 seconds of
pushing the starter button. If the unit fails to
start check the following.
1. Engine stop switch is "ON".
2. Parking Brake Locked "ON".
3. Tether switch is fully inserted.
4. If you used the remote switch to stop
the unit you must press the run button
to reset the receiver stop switch.
Driving your ATV
Your ATV should only be driven in an area
that is designated for this use. Insure that the
area is free of obstacles and other dangers
that could cause a loss of control. Check with
your local authorities for any regulations
regarding the use of your ATV.
Always keep your feet on the footrests and
your hands on the handle bar grips while
operating your ATV. Doing so will give you
the best control of the unit.
Start your ATV by following the starting
procedure above and allow the engine a few
minutes to warm up before releasing the
parking brake.
Start the unit by slowly increasing the throttle
until the unit begins moving.
Turning your ATV
Learning to turn your ATV requires you to learn
to shift your weight and control the throttle to
allow the rear wheels to turn properly. When
making a turn, the wheels on the outside of the
turn must travel a wider radius and thus a
greater distance than the inside wheels of the
turn. Since the rear axle does not permit a
different rate of rotation, it is not enough to
merely steer your ATV into the turn.
To turn properly, steer in the direction of the turn
and lean your body to the inside of the turn while
supporting your weight on the outer footrest. Use
the throttle to maintain power throughout the turn.
If you do not use this turning technique the unit
will have a tendency to continue in a straight line.
If this occurs, release the throttle lever to allow
the unit to stop.
Avoid braking or accelerating until you have
regained directional control.
Parking Your ATV
1. Always park your ATV on a level surface.
2. Turn the ignition key to the "OFF'"
position to stop the engine.
3. Set the engine stop switch to "OFF"
position.
4. Engage the parking brake locking button.
5. Turn the fuel valve to the "OFF" position.
6. Remove the ignition key to prevent
unauthorized use or theft of your ATV.
Page 15
Hide quick links:
Advertisement
Table of Contents
