Table of Contents
Advertisement
Replacement of gas oven burner
nozzle
To replace the gas oven nozzle, follow
this procedure:
1 1 1 1 1 . remove the bottom plate of the oven
cavity ("A").
2 2 2 2 2 . Undo the two fixing screws ("C") which
keep the oven gas burner in place.
3. Gently slide the oven gas burner off the
injector support ("D") and slowly move
it to the left hand side, taking care not
to cause stress to the spark plug con-
nection wire ("F") and the thermocou-
ple ("E") conductor.
4. With a socket spanner 7 unscrew and
remove the gas burner injector ("D"),
and replace it with the required one (see
table "Burner characteristics").
5. Reassemble the burner following the
same procedure in reverse.
6. Replace the Gas Type Sticker (it is lo-
cated near the gas connection ramp)
with the one relevant to the new gas
type which is supplied with the injector
kit.
Minimum level adjustment of gas
oven burner
After setting the oven on maximum
temperature with door closed for about 10
minutes, turn the knob to minimum.
To reach the thermostat by-pass screw
and adjust the minimum level, act as fol-
lows:
1. take out the gas oven control knob.
2. In case of conversion from natural gas
to LPG, tightly screw the by-pass screw
of thermostat (see diagram, letter "D").
3. In case of conversion from LPG to natu-
ral gas, unscrew the by-pass screw,
until a regular small flame is reached.
4. Finally check that turning quickly the tap
from maximum position to minimum
position, the flame does not go out.
5. Reassemble the knob.
Fig. 22
Fig. 23
Fig. 24
Fig. 25
electrolux 35
Advertisement
Table of Contents
