Adaptation To Different Kinds Of Gas - Electrolux EKG 6013 Instruction Booklet

34 electrolux

Adaptation to different kinds of gas

To adapt the appliance to a different
kind of gas from the one the appliance
has been set for, follow the instructions
below in their order.
Hob burners nozzles
1. Nozzles replacement
1. Remove the pan supports.
2. Extract the caps and the wall baffles
of the burners.
3. Using a socket spanner 7 unscrew
and remove (Fig. 20) the nozzles re-
placing them with the ones required
for the kind of gas in use (see table
"Burner characteristics").
4. Reassemble the parts following the
same procedure backwards.
5. Replace the rating label (placed near
the gas supply pipe) with the relevant
one for the new type of gas supply.
You can find this label in the package
of the injectors supplied with the ap-
pliance.
These burners do not need any pri-
mary air regulation.
2. Adjustment of minimum level 2. Adjustment of minimum level 2. Adjustment of minimum level
2. Adjustment of minimum level 2. Adjustment of minimum level
To adjust the minimum level:
1. Light the burner.
2. Turn the knob to the position of mini-
mum flame.
3. Remove the knob.
4a.When converting from natural gas to
LPG, tightly screw the by-pass screw
(Fig. 21).
4b.When converting from LPG to natu-
ral gas unscrew about one-fourth
turn by-pass screw, until a regular
small flame is reached.
Reassemble the parts following the
same procedure backwards.
Check that, turning quickly the knob
from the maximum position to the mini-
mum one, the flame does not go out.
By-pass screw
Fig. 20
Fig. 21