Tandem Trunking; Transfer - NEC DS1000 User Manual

Tandem Trunking

Tandem Trunking is disabled by default.
To set up a tandem call (Unsupervised Conference):
1. Place or answer an outside call.
2. Press CONF
3. Place or answer another outside call.
Press
4. CONF
- You can optionally press
CONF
To disconnect a tandem call (using Forced Trunk Disconnect):
1. Press line key for busy line (or use Direct Line Access) +
To Barge In on a tandem call:
- Use this procedure to rejoin a Conference already in progress.
1. Press line key for busy line (or use Direct Line Access) +

Transfer

Transfer is enabled by default.
To Transfer your call:
1. Do not hang up.
Press
2. TRANSFER
3. Dial your co-worker's extension number.
- You can also Transfer the call to a Ring Group or UCD Group master number.
4. Announce the call + Press
OR
Press the flashing line key to return to the call if your co-worker doesn't want it.
OR
Press
TALK
To Transfer your call to a co-worker's mailbox:
Do not hang up.
1.
2. Press TRANSFER
3. Dial 8
- To Transfer the call to your own mailbox, press your own Message Center key.
4. Press TALK
DS1000/2000 Cordless Telephone User Guide
.
+ to hang up.
TALK
HOLD
to reinstate the tandem call.
.
TALK to make a Screened Transfer.
to send the call through unscreened.
+ Dial your co-worker's extension.
.
to hang up.
to place the Conference on Hold. Press one of the line keys +
# to disconnect the line.
4 to Barge In.
Feature Operation
Chapter 2: Features ◆ 35
2