Table of Contents
Advertisement
18 electrolux
Commissioning
When the hob has been fully installed it will be necessary to check the minimum flame setting. To do
this, follow the procedure below.
1) Turn the gas tap to the MAX position and ignite.
2) Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX
several times. If the flame is unstable or is extinguished follow the procedure below.
Procedure:
1) Re-ignite the burner and set to MIN.
2) Remove the control knob.
3) To adjust, use a thin bladed
screwdriver and turn the adjustment
screw (it can be located down the
centre of the gas tap shaft or on the
tap body, according to the different
models - see Fig. 3) until the flame
is steady and does not extinguish,
when the knob is turned from MIN
to MAX. Repeat this procedure for
all burners.
Pressure Testing
1) Remove left hand pan support and front left burner cap and crown.
2) Fit manometer tube over the injector.
3) Turn on the burner gas supply and ignite another burner supply.
The pressure reading should be nominally 20 mbar and must be between 17 mbar
and 25 mbar.
4) Turn off the burner supplies.
Minimum adjustment screw
Fig. 3
Advertisement
Table of Contents
