Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Electrolux EHT60410K
Summary of Contents for Electrolux EHT60410K
- Page 1 instruction booklet gas hobs EHT 60410...
- Page 2 2 electrolux...
- Page 3 Thank you for choosing a first class product from Electrolux, which hopefully will provide you with lots of pleasure in the future. The Electrolux ambition is to offer a wide variety of quality products that make your life more comfortable.
-
Page 4: Table Of Contents
The following symbols will be found in the text to guide you throughout the Instructions: Safety Instructions Step by step instructions for an operation Hints and Tips Environmental information MANUFACTURER: ELECTROLUX ITALIA S.p.A. C.so Lino Zanussi, 30 33080 PORCIA (PN)- Italy... -
Page 5: Important Safety Information
Ensure a good ventilation around the appliance. A poor air supply could cause lack of oxygen. When using the hob for a long period time, the ventilation should be electrolux 5... - Page 6 6 electrolux improved, by opening a window or increasing the extractor speed. Do not use this hob if it is in contact with water. Do not operate the hob with wet hands. Appliances become very hot with use, and retain their heat for long periods after use.
-
Page 7: Description Of The Hob
Once the hob has been installed, it is important to remove any protective materials, which were put on in the factory. The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this book be ignored. electrolux 7... -
Page 8: Operation
8 electrolux Operation Hob burners control knobs The symbols on the knobs mean that : there is no gas supply there is maximum gas supply there is minimum gas supply Lighting the burners For easier lighting, proceed before putting a pan on the pan support. -
Page 9: Using The Hob Correctly
Do not place unstable or deformed pots on the rings: they could tip over or spill their contents, causing accidents. Pots must not enter the control zone. minimum maximum diameter diameter 180 mm 260 mm 120 mm 220 mm 80 mm 180 mm electrolux 9... -
Page 10: Maintenance And Cleaning
10 electrolux Maintenance and Cleaning Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply. The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. -
Page 11: Periodic Maintenance
(Page 8 - lett. B) are not obstructed. Periodic Maintenance Periodically ask your local Service Centre to check the conditions of the gas supply pipe and the pressure adjuster, if fitted. electrolux 11... -
Page 12: Something Not Working
12 electrolux Something Not Working? If the hob is not working correctly, please carry out the following checks before contacting your local Service Force Centre. SYMPTOM SYMPTOM SYMPTOM SYMPTOM SYMPTOM There is no spark when lighting the gas. The gas ring burns unevenly. -
Page 13: Instructions For The Installer
3 core flexible cable with non rewireable plug 1.9 kW (6485 BTU/HR) 1.9 kW (6485 BTU/HR) 2.9 kW Natural Gas (9898 BTU/HR) 2.7 kW L.P.G. 1.0 kW (3413 BTU/HR) GB - IE: II2H3+ Natural gas G20 (2H) 20 mbar electrolux 13... - Page 14 14 electrolux Characteristics of gas burners Characteristics of gas burners Characteristics of gas burners Characteristics of gas burners Characteristics of gas burners TYPE BURNERS Rapid NATURAL Semi-rapid Auxiliary Rapid LIQUID Semi-rapid Auxiliary Burner Dia. Tap By-pass 1/100 mm Auxiliary Semi-rapid...
-
Page 15: Important Safety Requirements
Domestic Gas Installation I.S. 813 Current Editions Table Four. is required. If it is installed in a room of volume an air vent of effective area of 50 cm no air vent is required. electrolux 15 an air vent of is required, and 11 m... -
Page 16: Installation
16 electrolux Installation IMPORTANT Any gas installation must be carried out by a GAS SAFE REGISTER installer. Please, ensure that, once the hob is installed, it is easily accessible for the engineer in the event of a breakdown. The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this instruction booklet be ignored. -
Page 17: Gas Connection
650 mm. For appliances installed in the Republic of Ireland please refer to NSAI- Domestic Gas Installation I.S 813 Current Edition Section 7- Permitted Locations of Appliance. electrolux 17... -
Page 18: Fitting The Hob Into The Worktop
18 electrolux Fitting the Hob into the Worktop Before fitting the hob into the cut out, an adhesive seal must be fitted to the underside outside edge of the hob. It is essential that no gaps are left in this seal in order to prevent spillage near the hob seeping into the cabinet below. -
Page 19: Building In
The panel fitted under the hob ("a") should be easily removable to allow easy access if technical assistance is needed. The space behind the kitchen unit ("b") can be used for connections. Dimensions are given in mm. ON/OFF SWITCH FLEX OUTLET electrolux 19 ON/OFF SWITCH FLEX OUTLET... -
Page 20: Electrical Connections
20 electrolux Electrical Connections Any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations. THIS HOB MUST BE EARTHED. The manufacturer declines any liability should these safety measures not be observed. -
Page 21: Permanent Connection
90 deg. C. Supply cable replacement The cable used to connect the hob to the electrical supply must comply to the specifications given below. Min. size Cable/flex Cable / flex type 0.75 mm H05 V2V2-F (T90) Fuse electrolux 21... -
Page 22: Commissioning
22 electrolux Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. 1) Turn the gas tap to the MAX position and ignite. 2) Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times. -
Page 23: Conversion From Natural Gas To Lpg
LPG injectors. TO ADJUST THE GAS RATE With the aid of a thin bladed screwdriver completely tighten down the by pass adjustment screw. Upon completion stick the replacement rating plate on the under side of the hob. electrolux 23... -
Page 24: Standard Guarantee Conditions
24 electrolux Standard Guarantee Conditions We, Electrolux, undertake that if within 12 months of the date of the purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: •The appliance has been correctly installed and used only on the gas and electricity... - Page 25 Please note a valid purchase receipt or guarantee documentation is required for in guarantee service calls. Customer Care For general enquiries concerning your Electrolux appliance, or for further information on Electrolux products please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.electrolux.co.uk...
-
Page 26: European Guarantee
• The appliance is installed and used in accordance with instructions issued by Electrolux and is only used within the home, i.e. is not used for commercial purposes. • The appliance is installed in accordance with all relevant regulations in force within your new country of residence. - Page 27 27...
- Page 28 39714-4201 11/09...